[Specification] ・Rated voltage: DC12V ・Outer diameter dimension: W25.5mm x H30.5mm x D15.5mm (*excluding protruding parts)
[Components] ・Main unit x 1 ・Double-sided tape x 2 (1mm thick, 2mm thick, 1 each) (*Use 1 tape for temporary fixing during setting.) ・Instruction manual
*This product is for 12V motorcycles (battery-powered vehicles) only. *This product cannot be installed on vehicles with point ignition type.The high voltage generated when the key is turned from ON to OFF may short-circuit the SPI unit and cause a failure.(Ex) HONDA CB400FOUR In the case of HONDA CB400FOUR, there is a case that SPI was short-circuited because 65V (+20V, -45V) were generated at the moment when the key was turned from ON to OFF. *This product is only for motorcycles with electric speedometers.When installing on a mechanical speedometer (meter cable type), please purchase the optional pulse generator PG-110. *When the clutch is depressed while driving, the display shows a gear other than the one in which the clutch is engaged, but this is not a malfunction. *Prioritize safety while driving and do not be careless in front.
*Please do not use non-resistive spark plugs.If you use a plug without resistance, noise may be generated and the rotation signal may not be input correctly, so please use a spark plug with resistance. *Please put the attached double-sided tape on the back side of this product to prevent water from entering because there is a switch. *Install the product correctly according to the instruction manual.Improper installation may result in fire or equipment damage. *After installing this product, periodically inspect it to see if any parts have fallen off. *PROTEC is not responsible for any damage or accident caused by the use of this product. *Protec is not responsible for any labor charges for removal or other expenses incurred during repair. *All vehicles that have been tested by Protec are stock.There is a possibility that a problem may occur if the vehicle is equipped with aftermarket parts other than stock parts. *This product can be used for vehicles that are not listed in the compatibility information below.Please refer to the list for the required parts. *Please refer to the service manual of your motorcycle to confirm the respective wiring before installation. *Some Harley-Davidson [TC96 '05] injection models do not work with SPI.If you are planning to install the product, please contact PROTEC before purchase. *For other Harley-Davidson models, it can be installed on with the SPI-110 and optional PG-110 + PG-220.
●Digital display Suitable for vehicles with electric speedometer. *Mechanical speedometer (meter cable type) and mechanical tachometer (without tachometer) models require a optional part separately.
●Compact design! The main unit dimensions are W25.5mm x H30.5mm x D15.5mm (excluding protruding parts), a compact design that does not interfere with installation around the meter.
●LED display for high visibility! Equipped with a dimmer sensor [automatic dimming function].The brightness of the LED is automatically adjusted to be brighter in the daytime and darker at night to improve the visibility of the digital numerals.
●Equipped with a shift up indicator! Since the rpm can be set arbitrarily, it can be used for everything from narrowing to preventing over-revving.The blue LED will light up when the rotation is higher than the set value.*You can re-register as many times as you like.
Points of Attention
* If there may be an instruction manual included, it will be written in Japanese.
Recently viewed products
Ratings & reviews for this product or related products
ManufacturerSite has installation examples for each car model, so I used that as a reference.
The Kit does not include the terminals and resistors necessary for coupling, so you will need to make your own arrangements for these.
Also, there was a mistake in the Wiring color in the Manufacturer's installation example, so it was not easy to install. Although Neutral is said to be GreenWhite in the Manufacturer, it is really light blue.
If your car does not have the kit, you will need to use the Skill for installation.View Detail
The only way to install it was with Universal, so it was not a pompous installation There is some lag in the display You won't be able to get into the phantom seventh gear, and being able to check what speed you're driving at all the time will give you peace of mind It is There are other features, and it's quite a recommendationView Detail
There are no problems with the accuracy of the display that I am concerned about It reacts after the Clutch is connected, so it's not possible to change the position while the Clutch is off The correct GEAR is not displayed when you do Chica Chi It is necessary to purchase dedicated parts for both mechanical and electric meters There are, so check it out carefully This eliminates the phantom XX speed & hellip;View Detail
This model also has Motorcycle and Engine characteristics like Racer impossible to install security parts. In urban driving you can use only up to the 3rd gear, and even if it is Highway it will be painful even if it is 5th gear. Therefore, in the speed range of 4th speed or higher, you will not know what speed you are currently running ? ? ? Because there were many seven speeds of phantom so much, it was 200% good for me to put on a guy (Lol)
If you use dedicated Harness for installation, it is completed in 30 minutes, including Cowl removal, return and Wiring handling!
Product title SP1 is dedicated but since GEAR ratio is the same, it is OK to install SP2 without problem!
Because Mission is CROSS it was difficult to understand what speed is entering now, so I bought it. CBR 600 RR PC 37 Later, we purchased Universal Product because there is no special item. It was uneasy because I had never messed with an electrical system, but rather it took more time to install and remove Cowl. If it is a car model that conformity has been confirmed even with Universal Product, we can see Wiring to be installed at Site, so I think that the installation itself is possible if the hand is dexterous.
Downshift has its function changed itself, its display changes, but SHIFT UP got somewhat lagged. Only dissatisfaction is there.
I feel that it will become an indispensable item once I turn on it. View Detail
* The BEST and MUST store to find Japanese parts. * Register now for amazing deals and other special offers! *Over 800,000 listed items. It's hard NOT to find your parts.
SIGN IN TO WEBIKE JAPAN
Please enter email at least 6 characters.
Please enter a valid email address.
Email is already in use.
Your account has been banned.
Email address and/or password is not match.
Authentication with facebook fail.Please try again.
Please select How did you get to know about Webike Japan?
OR
YOUR ACCOUNT HAS BEEN CREATED!
Congratulations! Your new account has been successfully created! You can now take advantage of member privileges to enhance your online
shopping experience with us. If you have ANY questions about the
operation of this online shop, please email Webike through CONTACT US.
A confirmation has been sent to the provided email address. If you
have not received it within the hour, please contact us.
Get on your grid by register your motorcycle! About our "Mybike" service
"Easier to Search Items" It helps you to search items to fit for your motorcycle!
"Get Much Valuable Information" It helps you to get special deals, newly listed items and closeouts about your motorcycle!
"Easy to Register" It requires only your motorcycle manufacturer, model name and model year!