- I bought it because it said it was compatible with DJEBEL250, so I thought it would also be compatible with XC, but the shape did not fit and I could not install it.I contacted them in a panic to retu...Read More
- I am generally satisfied, but it would be helpful if the Bolt for adjustment were longer. I am using it almost all the way to the root.Also, I would like to see Clutch and Brake sold separately.Read More
- I always buy this.It is a spare in case of breakage, but it breaks quite a bit when knocked down, so if it bends even a little, it is replaced immediately.It is easy to grip and short, so it does not ...Read More
- [How is it used?Installed on TS125R.Application:Off-roadUsed for about 6 years. Many times overturned.Was the one you received as per Image?As shown in the image. Since my hands are so small, I needed...Read More
- I bought this as a spare for my wife's motorcycle. It is much easier to grip than the OEM and my wife noticed the difference. I think I'll use this for my motorcycle too.Read More
- I replaced the NORMALLever with this product because it got bent due to standing moss.Since the vehicle body is light and Caliper is a single push 2 pod, Brake can be operated without a problem even w...Read More
- Short lever can be described as RALLYI am satisfied with the texture, feel and CostLargeIt is a repeat order, but it is a long term relationshipRead More
- I changed it to install a Knuckle guard in FTRNORMALLever, it's too long to wearI feel like the pull is easier than NORMALThe exchange is easy and RecommendationRead More
- I really wanted a Foldable with a play adjustment Lever, but I didn't think so It was expensive and not a compatible carI chose this one as the only one that fits and is cheap and reputable because ch...Read More
- I installed it on my CRM250RR It was replaced due to a standing mock-up I was using other levers until they arrived, but the feel of the controls didn't feel right This Lever feels good when you pull ...Read More
- Mounting on XG250 TRICKERI could install it without any problem.Regarding length, it may be a bit too short for those who operate with three fingers.Read More
- I installed it on my CRM250 The same thing was attached before the exchange, but it was damaged and I replaced it with a standard type Lever I used to use it, but it didn't feel right, so I had to rep...Read More
- I had already attached to Motorcycle purchased in second handPo Drill at the first fallRecommended to VeteranRider when looking for the next LeverAccording to that personIt is better not to break abso...Read More
- In the case of the carburetorD tiger on which I am riding, I adopt the famous place because there are few Lever choices.I have just started using it, but I do not have any problem in using it.I feel I...Read More
- XTZ125 (CHINA) Mounting onBrake master cylinder Press Piston Screw and Nut purchase separately for SEROW (About 200 yen) Both Clutch and Brake are attached. The length of Lever is Ball 1 pc. It is an ...Read More
- I used it for DJEBEL.As the other person wrote, the position where Mistress Cylinder's Piston is pressed,I am out of alignment..I am pushing towards the edge of Piston.Lever ratio also changed, an...Read More
THE LARGEST
SHOP IN JAPAN
EXCLUSIVE COUPONS,
SALE, DEALS
FAST, RELIABLE
SHIPPING